Hmm. Looks smaller diameter than mine. I need to get a smaller one
Litneon what brake booster is that off of? Or is it still the stock one?
My uppers need spaced as well.. so ill do some spacers on both.. I go all my exhaust ran, new muffler, truck is back running, all air stuff hooked...
Haha. Does it have anything to do with emissions? Some of the lame cities in utah still make u do emissions
What do I do with this contraption after I get rid of the air box and do the shorty air intake setup??
Oh yea for sure.. I bought spacers from lowes today for that reason.. I just did it like that so I could get the truck down to redo my rear bag...
Another pic of the back
Well heres some updates... frontend done, tranny cross member done, rear bag mounts with just some simple tube support all tacked up and ready to...
Ok.. my pinion changes 2 degrees over 7-8" of travel
So I checked it. The tranny is pointing down 4 degrees, and I adjusted my link bar so the axle is pointing up 2 degrees.. is that bad or do I need...
So heres the driveline tranny angle.. does this look like the tranny is pointing down to much? The rear end is jacked up to roughly bout ride...
Haha ok.. had me confused there for a min..
Ok. Yea if I have the tranny jacked up I can get it to 4-5 degrees down.. so when I cut the motor mount I wanna cut at a right andle instead of...
Haha.. I kno.. I just didnt wanna drop the motor mounts if I didnt have to haha.. k I kno I asked u once before.. I cut the motor mounts, slide...
Ok so I finished gettin the new control arms and bag brackets on the front, pretty much finished with that.. ill post pics tomorrow, , onto the...
:rolleyes::rolleyes:Oh yea I put anti seize on the lower bolts.. hmm yea I dont remember if the lower ball joints were a bit tough or not to get...
I would if I messed with pics on forums more haha.. I prob wont post that much more for pics after I finish this build man..
Anyone else have a pita time try to get the lower ball joint screwed fully in on these cando arms? Bout the last 5-6 threads were a pain
Well got the rear bag mounts off so I can raise em a lil to lay frame.. finished the wheel tubs in the front and the Z is all done, , some...
Kbs has it for 130.. its easier as far as labor and costvto buy one vs. Building one.. I debated this same thing man
Separate names with a comma.
