Dash Cam: Canton PD "Notification" Arrest & Officer Goes Berserk / Threatens‏ - YouTube
Nazareth Carpenter Being Held On Charges Involving Underage Mother 12/25/10 --"Information Clearing House" - Bethlehem, Judea - Authorities...
I see six options: 1: Wire the two sockets in parallel and have the white flash with the yellow. 2: Wire the yellow to flash, and the clear...
As I understand Alternators to function, the voltage output id determined by regulating the input to the field coils. If there is an internal...
Why is it no one ever thinks of using a MOPAR small block into these projects?:shrug: 318's are readily available, damn near bullet proof,...
If I recall correctly the 21R series engine was a 1.8L based on the same engine casting as the 20/22r. It was never imported to the US in any...
He used to sell 20r stuff a few years back, but probably dropped it due to lack of demand. I remember that the prices when he DID carry 20r...
I know it's MOPAR, but here is a good shade-tree explanation of how runner length affects power curves. Money quote:
That long thread about the 'milkshake' oil wasn't me. I just referenced the thread for the photo's, and also in case someone was interested in...
The timing chain cover bolts to the front (face) of the engine block. IF the guide has broken and you have serious wear on the cover, then you may...
Did he offer a reach around with that quote? If you can work a wrench and screwdriver you can do this repair. You will need a pulley remover...
May not be electrical at all. On my 77 the plastic bushing that connects the motor to the arm disintegrated allowing the arm to fall off. The...
To address the non-functioning rear brakes, the fluid on the one side suggests to me that you have a crack/break in the line somewhere (probably...
20r head w/ mechanical pump...droooooool......:drool:
...changed out the oil&filter, air filter, spark plugs, two radiator hoses, and the radiator cap (cracked gasket), set the valve lash (1/2 were...
HRMmm......How long does it take to swap beds on a couple of trucks? Think it could be done in a day (two days tops)? I'm heading to Florida in...
Like the title says. Local junkyards are no-joy for what I need. The handle/frame assemblies are plastic, and the mounting point for the...
According to Chiltons, the 84 has a basic electronic control module for emissions, even on the carb models. I'm wanting to (eventually) do an...
Never said I was going to scrap it. The 77's engine will get pulled and gone through at leisure over the winter, installed in my 81 4x4, whose...
It's a 77. No cat. Swapped the carb to a Weber 32/36. The only vacuum lines are for the PCV (freshly installed), the brake booster, and the...
Separate names with a comma.
