Hi all, I just installed some Belltech drop spindles on my truck, and my camber is waaay out. I already had 1/8" of shims, and added 2 more 1/8"...
Hi all, I've been doing some more night driving in the hills these days, and the roads are quite twisty. I'm needing some better lighting for...
To all of y'all out there running e-fans, what do you use to control the temperature?
Are there any know issues with swapping a dash from a 4runner into a Pickup? I kinda figure all the sensors are the same, and they are both cable...
I have brought 2 locks to my machinist in hopes to have them bored for some .040 over postons that I have. Both are nearly at .060 over. So do I...
I need a new block for my truck, but am not finding any bare blocks readily available. I have, however, found a few long blocks for sale. I've got...
Hi all, I have to drop my A340e transmission and was wondering if y'all had any advice. The truck is currently a foot in the air on jack...
Hi all, I'm about to start sanding down and prepping my engine bay for a fresh coat of paint. I was wondering if anyone had suggestions on any...
I have a 22RET, and the steel coolant pipe that wraps around the driver's side motor mount is starting to pinhole and leak. As this is a turbo...
Hi all, I'm having some issues with my 22RTE. I've been doing a lot of driving around at speeds under 60mph, and so much has been wonderful. I...
Hi all, I've had some questions here and there recently about the AFM upgrade that I recently did, so here is a little run through for ya....
I've been playing with different setups on my bumper lights with different covers and bulbs, and found one that I think works quite well. It uses...
Is anyone familiar with transgo shift kits for our automatic transmissions? my last truck had the clutch discs go bad, and prolonged clutch dusc...
I have been trying to track down some lower end rattle after an engine swap. I haven't been able to get the bearing caps off of the rods or mains...
Hi friends, I have finished up building my new engine, and plan to drop it in the truck next wednesday. I have never done this before, I didn't...
Hi, I was cleaning out my shed in preparation for some upcoming engine work, and came a cross a few extra bits that I would like to offer to you...
I have been wanting to replace my head for quite a while, and am finally in a place in life where I can actually pursue this effort. I have been...
I know this is a fairly common thing, but in most cases it seems to have been a slow process of being hard to start to only starting infrequently...
Has anyone seen a chrome tailgate handle for a 1984-88 for sale anywhere? I know that I have tried a few times, and all I can see is black or...
I've got a couple electric fans to cool my engine, and have noticed dropped idles when both fans are on. I don't have A/C, so was wondering if...
Separate names with a comma.