So I ended up buying an oil catch can. I ran the line to the can itself, and capped off the other end. Went on a 60 mile round trip drive and...
I have a check valve on the booster, and one on the PCV system. I'm going to swap locations of the hoses and see if that makes a difference....
I'll make this change and see how it works out. Anything else I can do to cut down on the oil coming out of the breather? Can you hookup a...
Should the booster have the check valve in line and not the PCV? I just have it setup this way because thats how it was when I bought it.
The line from the booster, and the PCV connect to the intake manifold [IMG]
I had this issue with my 20R but it wouldn't happen all the time, but with my 22R there must be a little more blowby and I constantly have to wipe...
The idle was up near 1000rpm. My experience with tuning a carb is very limited and anything lower would start to run worse. Driving it around town...
These are the same mounts I used on the 20R. Honestly that is what it feels like. Not solid mounts, but if you replaced the OEM mounts with...
Never considered this. I was just always impressed how smooth the 20R felt once I had the weber installed.
It does sound like it's coming from the rockers. I've adjusted them to the best of my ability but it's entirely possible its not where it should be.
I did notice a small exhaust leak on the manifold. Looks like I may have a stripped stud. I've tuned the carb the best I know how using the...
It's not terrible but the 20R was much smoother in comparison. The idle is around 900-1000 and any lower will aggerate the problem. Here is a...
Is it possible this could also be the cause of the vibration? I sounds as if it's coming from the rear of the valve cover area.
I have a little video I shot today and will upload it tomorrow. One thing I did notice is the sound appears to have changed slightly (...or I'm...
I had to do the same. Super sketchy and I swore I'd never do that again. Haha
When you reinstalled it separate did you install the trans after installing the engine?
Trying to diagnose a vibration issue I'm having and it looks like I may need to inspect the flywheel/clutch. Maybe it's just me but it's a pain in...
Thanks for your reply. Unfortunately when I removed the flywheel to get this on an engine stand I didn't bother marking the orientation of the...
Just completed a 20R to 22R swap on my 77. Swapped the w50 from the 20R (originally was on this engine) back onto the 22R. I've driven the 78...
Just an update on my wiring issue. No issues so far with how everything is wired and the ALT is charing the battery so I'm going to leave...
Separate names with a comma.