The chrome trim rings that hold the bulbs in place can be removed with a thin shanked Phillips screwdriver. I’ve changed my bulbs without removing...
What is available in bucket seats that will fit into a 1978 cab with minimum alterations? My current seats need replacement. Prefer something...
Check the steering box for lube. 90W is what the factory recommends. There should be a fill plug on top of the selector shaft cover. Make sure...
40+ year old steering boxes are all sloppy. Check for play in your pitman arm and idler arm. These two things if worn, will make your steering sloppy.
Are you running 2 batteries or just 1? Many times heavy amp drawing accessories overload the standard 12 volt system. If not already doing so,...
Dorman 49450 Wiper Motor Bushings - Universal, 3 Pack https://a.co/d/0q6rt27 Maybe something like this might work.
New mc shouldn’t be leaking.
Did you bench bleed your new mc? I agree with jetas. Sounds like air in the system someplace.
I just stuff a shop rag into the tail shaft and wrap with duct tape.
water temperature sender should be yellow with green stripe. Easy way to check that is with the ignition switch “on” touch the bare wire to a...
That’s a really dangerous setup. You have no idiot light to tell you when you loose oil pressure. Gages are ok as long as you keep a constant eye...
Did a little more exploring on the wiring harness. The oil pressure sender wire comes out of the same wire loom as the water temperature sender...
Is the sender still there?
Left a comment under your #2 picture.
Had to clean some crud off but this is what your ops should look like. Very similar in appearance to a water temperature sender. Other picture is...
Yes, you’re correct. When using an external oil pressure gage a “T” fitting is usually installed into the threaded ops hole on the block. The ops...
Mr. D is right. Modular plug, single wire, yellow with black or dark blue stripe. Can’t depend on memory any longer.
Yep. It’s a simple two wire plug. Mine rests about 1/2 way down the passenger inner fender. Should be able to trace it directly to the OPS.
Unhook the two wire plug that runs from the harness to the oil pressure sender. This fools the pump into thinking it’s grounded. The pump should...
Good to hear. Leave that heat shield off. Not one of Toyota’s better ideas.
Separate names with a comma.
