I want to say es2093r is your inner tie rods. Rock auto is good for parts like that. If you end up redoing the brakes you'll find the front on...
Not to worried about it being targeted because of it. If anything people will just think I'm being a ricer and have a broken latch. Lmao I think...
Got some locking hood pins installed. The latch is acting up and the cable broke. I'll still replace those down the road but they're pricey for...
Weird you have an indent for a finger to lift the door.
You had a fuel door?
Had a big scare in the hilux. I ripping around town doing burnouts off every light. When I get to the last one and in the middle of it I here a...
The stroker is one of those things on these engines isn't a good route. The increase in power is very minimal and you're way better off going all...
Timing chain probably ate up the timing cover because of a broken right side guide.
Yup. Thanks
Im looking to get the wheel hub assembly pages. Doing the front wheel bearings soon.
I would say the lever definitely helps with the pull. You probably will have to give it your all with two hands for a chance to hold on a hill....
That looks like the spot only problem is someone ran a wire through the hole. Might be best to reroute it though a hole with a grommet anyway. I...
Is the cluster required for the ecu? If not I wouldn't try to retro fit it and everything. The original cluster is way better looking. The other...
If the firewall was cut it may of been removed. You should see a cable guild on the firewall. From there it would cross over the trans and go to a...
Finally had a day where it didn't rain all day. Tuned up the truck and got the new spark plugs in. Thinking I might have a float or needle problem...
Looking at it on my early model the top pin is riveted. And it dosnt look like there is enough meat for the keyed part of the pin on the part of...
I ordered this kit. Haven't got around to installing them. From my understanding the original is like a rivet that will need to be drilled or cut...
Not to go in a whole debate in this thread but the track width would be about the same and the weight of the miata is about the same as a toyota...
Driftworks used the subframe from a miata in a first gen. The differential probably won't handle the power you are after but I'm sure they have...
Didn't notice i was in the 76 and up. Maybe more people will see it. One thing I did find out is some of these small computers don't have real...
Separate names with a comma.
