Look at the oil you drained out..or did you do the change? If not drain it and look for bearing debris
Run down to your parts store....
Sounds like a wrist pin maybe?
Choke acting up then? Since its carb'd
Carb'd or EFI?
crazy yes....but it would be a good opportunity to clean..alot more work though. It can be done in a day with the correct tools and preparation...
I see your 4wd diff...coated in oil. More than likely its a valve cover gasket leak, but while your doing all that, a new oil pan gasket, timing...
Id cover the distributor and the AFM.other than that, go to town.
Being that it wont start untl cold...to me means it has to go back into open loop mode, meaning i tignores the input from the o2 sensor...once the...
Welcome....I have a profile on YotaTech as well...project91. I did a write up on swapping a 01-04 clip to a 96 model Tacoma....I dont spend any...
For the same price of stock repplacement rotors you can get cross drilled slotted rotors off ebay. I did..they work great. Not Wilwood or...
This. Theres no way to modify the bed sheetmetal and get the arch to look correct.
Yes. Run a 30 series tire.
Very nice.
Nope...the valnce is un modified. It is scratched from laying out and rolling a lil bit lol.
Looks good, but why is the upper plate so angled...that reduces lift...and already has the plate at a structural disadvantage.. When you air up...
22k....so your engine can rev to 22,000rpm......damn.:doah:
^^ Agreed. Thats what was causing mine. I took it off, traced it on a piece of sheet metal and made a block plate. My truck is a wknd and show...
Thanks man I need to get back on it...wheel tubs in rear are next
Check the amount of camber shims you have on the pass side versus the driver side...could be too many, and that coupled with the lower control arm...
Separate names with a comma.
