is there any how to on how to connect the turn signals that are right next to the headlights to the turn signals on the bumper so the lights on the bumper could always stay on.????
yes! i could get a write up for you! ive done it. also i could make the tailights reverse light be my signal and my signal be my reverse.
ha tell me how... because i wanna convert the bumper lights to be fogs so they will always be on.. i tried wiring them right now but that was a big <h1>FAIL</h1>
Do you have a 4 runner front end or reg. As for me, with my runner turn signals. I was able to find a 3 wire bulb socket with a double fillement bulb that mounted right in. Hooked both wires back up to the turn signal harness & then jumped the third wire to the parking lamp. So its always on like they were fog lamps, but still flash when signaling. (As for where to get the 3 wire harness. Good luck unless your here in Guam).
ahh man.. okay i understood some... i have the regular 85 sr5 hilux all i did was take out the cable from the side light ran a cable from positive to the + of the fog then i ran the negative wire to the negative of the fog and still ddnt get it to stay on but idk im not a big wiz when it comes to car stuff.. only a big wiz for electrical in houses
Your stock bulb socket is a single fillement. it can only do one function. For example if you look at your brake light bulbs you ca see a double fillement which enables it to stay on with your parking lights on, then get brighter when the pedal is applied. so the same with the signals youll need to get a harness which is like the brake in terms of functions. (double fill., 3 wires). your current set up only has 2 wires which tell the bulb when to flash. If you got a 3 wire harness then it could stay on by jumping it to the parking, & flash through its on regular function.
okay so let me get this straight... if i get the double fillment.. all i have to do is run one wire from where?? to the bulb so it could stay on all the time??
your current bulb is single fill., & your bulb socket is only made for that. So thats why you need a bulb socket & harness for a double fillement, which will have 3 wires. you would then cut your harness & wire the new socket in (2 WIRES), & the third wire would then be jumped from the parking lights up top.
go get a extra set of tail lights, all you need is 2 light sockets. take the socket for the brake/running light and trasplant it into the corner light housing. wire it up. you want the socket with the 2 lil dots on the contact patch, and they also have the offset tab bulbs.
