i have a 92 extracab 2wd pickup.

my brother has a set of 16x8 +18 (F) and 16x8 -10 (R). The rears fit fine w/o any issues...the front is another story.
How can i get these to fit? what size spacer/adapter or kits do you guys have?

Iciba USA has a set of hubcentric bolt on adapters for sale with the following sizes:
15mm, 20mm, and 25mm
Bolt Pattern: 5/114.3
Center Bore: 60.1
Thread: 12x1.5

Will these work? if so which one would you all recommend?

 

I'm sure the centre bore on those is too small to fit a Hilux, can't remember the measurement off the top of my head though.

Callum

 

by chance do you know the center bore of the hilux?

 

They should bolt straight on... Try cleaning the hub and the rim's center bore of any crud, rust, etc... It's a snug fit but, you shouldn't need any spacers to run em'...

 

Sorry, I was referring to the centre bore on the bolt on adaptor, I think they are either 64mm or 67mm for the Hilux.

Callum

 

67 from a post I saw here earlier today

 

Stock center bore is 67.06mm from the s2000 wheel question below.

 

sweet..thanks guys...i'll clean the crap out of it when i get my next day off and i'll finally post some pics of my daily.

 

i did a lot reseach , starions has the exact same center bore as pickups 67.1mm stock , they would fit without any problem , you dont even need the hub centric rings, offset is nice on those starions, iv been trying to get some lately

 

i appreciate it.