i know there are plenty of forums on wheel fitment questions and such on here but did not see many people skewing away from flush fitment. im looking to fit 16x10 -30 to -38 offset. may run stock fenders and bed if i can get my hands on -33 offset. If i end up going -38 i think i will run 4x4 fender and fab a flare for the rear. if anyone has similar fitment and could post a couple pics i would appreciate it.

 

I think the reason why it's not done often is the fender shape, to make lots of poke look good you must also achieve ultimate low; these trucks look pretty cool with the 2wd fenders pulled a bunch to be round and um fanned..kinda interrupting the more rectangular factory shape.

Let me find a photo

 

Didn't find the photo or video I was looking for, the one I wanted was 2j not a four cylinder, but it's close.






Here's some lovely photos I found by searching "stance"











This gen is hard to run lots of poke, kinda worried the fenders and having suspension travel, but very doable