I have a set that im about to install and suggestions or anyone know of any problems when doing this install?

 

Where are they from?

 

I know on my cando arms I had to use washers on the ball joint so the cotter pin would go through the castle nut idk how other arms are. And I used lots of anti seize on the lower conrtol arm bolt

 

They are from CANDO obviously bought them a while ago.

 

Other than those things I mentioned theyre easy install and very nice

 

Thank you.

 

No problem man

 

Im going to try to install them this weekend.

 

I bought the same ones from (formally CanDo) KBS Fabrication. I don't know if it's the same with all spindles but I also bought drop spindles and had to find spacers and grind off one side to make the spacers fit. Some advice for anyone else doing this would be to asked them for some extra spacers when buying their arms if you plan on buying drop spindles. The ones that come with the arms are a special item buy and not very common.

 

I haven't installed these due to I started body dropping mine I'll try to do a build thread here soon.

 

Are you doing a traditional bd or sfbd?

 

I'm going stock floor body drop.

 

Please post a link to the tread, I need ideas for mine. Not sure yet on where to start. I want to do a sfbd also.