Xs5875 hey am I going to need spacers or they will bolt on with no problem Also am I going to need fenders rolled. I ask because I was going to buy some Rotas grid wheels but I went to a shop and they called asked for 17x9 but only make them in Green and I wanted black. :-( so I found these
You'll want something in the 7" wide +35mm range. Diameter is up to you. And make sure the center hub hole is large enough. I think out trucks need 67mm. Correct me of im wrong.
9" wide may work up front depending on your drop an how much offset it has. It could hit the control arm or tie rod linkage at full steering lock though.
my 18x10's don't touch my control arm or tie rods at +22mm. It only brushes the strut rod, that's it, but barely.
am still not sure what wheels to get. I found the work wheels that caught my eyes but then I found this but don't know if they will fit . I want 17x9 have a good looking offset then I'll add a clean tire tucking drop. So thanks for any info.
Those will fit fine. I have 4wd fenders on my truck and 10" width with +22mm offset will tuck tire and leave it flush. Minor fender rolling if anything.
i forgot the 79-95 trucks have a lower I arm and strut rod, not an A arm like the 78 and older. And i also didnt think of the offset with an 18 vs 16, which is what i have most experiance with. getting 17s soon tho. finally stepping up to the big leagues haha. even though i keep seeing luxs on 18s and 20s. *cough cough burnz*
The strut rod that goes from the LCA to the front is the only thing that it should rub at full lock, this is with a ball joint flip. That's also a 17" rim, so the diameter is smaller, so it might meet the strut arm a little earlier. I had 16's before, too. but aside from that, 17x9's +22 will be nothing. I fit something a little more extreme.
