thanks man. yea, the truck is notched....... has a deep 8" notch so there is lots of space and truck does not bottom out.

if youre gonna go this low you will need a decent notch out back. after about 4-5 inches you will run into frame smack issues with the rear axle.

here's my setup man.............. 3" belltech drop leafs and 3" bnlocks out back. 3" djm, LCA's, 2" belltech drop spindles, 1" bj flip, and cranked torsions out front.,

Look & see if there are 2 nuts on the top, cause there was on my truck. They do that to lock them in place & to prevent them from moving. Dont cut the bolts ok...they have a ton to tension on them & can hurt you!! Another thing you can do to help is make sure the truck front tires are off the ground. That helps relieve so of the pressure off the bolts. I had some top nuts do that before to me...I removed one top nut at a time, but I wedged a closed in wrench up at the top to keep it-(the nut) from turning & used my 1/2 drive & socket to turn it at the bottom. Try that & let me know what happens...Donny