Well it not much to look at right now. But i traded a pos blazer for this and 300.00 lol




here she is o dont mind the dates lol

 

took all this crap off lol



6x8s in the dash now

 

found this lol

 

took these out

added the 4 inch blocks




and did this

 

started to paint frame today. its only temp till i get the product i want


well it finally cooled down some so i finished the rear of the frame. i missed a few spots though lol o well





and did some more bay work
can u see the changes???

 

well did some more tonight. I figured since i tucked a little harness, i should it do it all lol

so started in the cab bla bla bla
and i always had this smell when i turned the heat on lol well som bitch look at this lol
this is what fell out of the blow motor housing lol


and this was still left in there with the pile on the floor


then started the tuck if ya look at the pervious pics you should be able to notice what i have done




inside after engine harness was ran in


still need to install fuse box and crap for headlights ect ect
and relocate battery to the bed

 

Nice little truck. Good start getting her closer to the ground. Tht bedside is torn up

 

ya i hear ya man been searching for a bed or bedside for it. cant find crap for it, well i can but its like a 700 miles or so round trip lol

 

I found a place that sells bedsides they're 234$ it's called rockauto.com

 

thanks ill check that out

 

Nice man, looks like a promising project.

 

does it still run good with removing all those vacuum lines?

 

nice start. yea go to rockauto unless u can get the bedside cheaper.

 

ya man runs better then before lol

 

Looks like it came with an instant rebate, too! About $1.75? Heh.

Nice lookin' truck.

 

nice man! hittin the ground and runnin already, great start!

that throttle body could use a little cleanin too though, probably wouldnt hurt to do a seafoam treatment or two......

 

lol ya also last night when i removed the grill i found a 10mm grearwrench lo

ya thanks. Ill prob get to the motor work sooner or later lol
I wish i had taken pics before i started to work in the bay area. Man the grease dirt film was so thick. You couldnt read the TOYOTA in the vc let alone even see it lol, it was pretty thick

 

He did the battery disappear mod! ZOMG! haha

He put the centering block on top of the drop blocks, SMART MAN! finally someone that actually did what I did!

anyway sir, you're getting somewhere! props on progress

 

Looking good. Can you give extra details on how you switched the battery from the rightside to the left. Did you just extend the pos/neg wire? Also which vacumn lines did you plug/remove- looks real clean.
Thanks