Yeah i followed this build
http://www.toyotaminis.com/forum/suspension-chassis-40/how-clutch-master-flip-under-dash-16482/

It was a lot easier than i expected.

 

Awesome thank you!

 

I am getting very close to getting this back on the road.
I need to trim the bed to fit on the frame rails since i bobbed 7 inches out of the bed.
I am repainting my interior before i put it back im and hope to have that done this weekend.
I need to run my hard line and install my accuair as well as the air tank and compressors.
Install my fuel cell.
I do have plans for a new motor and paint as well as a custom bed cover but all that will have to wait until winter or spring, I am taking my wife on an expensive vacation this year and I am trying to save for it.

 

Looking good!

 

Looks good bro. I like what you did to the bed

 

Thanks guys! Yeah i bobbed the bed 7 inches and use the remaining floor to make it flow a little better. It is not finished of coarse but on its way.

 

Ive read through your whole build today and yesterday. I must say, BEAUTIFULLY DONE. Oh, and yes this is my first post!

 

Awesome! Welcome to toyotaminis.com and thanks for checking out my thread. I have finally been driving it and loving it being back on the road.

 

It's been a while since I've been on the form. Your trucks came along way. Keep it up

 

Thanks! Yeah I haven't been on here much but figured I would throw up a picture