I have a question that might've been asked before but no luck finding info. I have a 92 2wd single cab short bed. And I want to order a set of diamond wheels. And I have no clue how or what to do as far as fitment goes no experience on that. I wanna run either 15x8s or 15x10s which would be better to get a slight poke but a nice fitment.

Thanx in advance.

 

15x8 zero offset will get you close to the fender and allow for room to lower it with the right tire 15x10 will work but stick out a little further if its a zero offset wheel and may come in contact with the fenders if you lower it to much ..think you will be satisfied with 8 wide wheels and a zero offset ..it's flush with fender . And it's possible to add spacers if you want it to stick out past the fender a hair

 

**** run the 15x10 and put 4x4 fenders on the fornt. That's all you need to do.

 

Thanx guys, I can run any offset but they ask me all these questions that I no clue what they so yea I think ill run 8s but will they fit flush in the rear?

 

If there zero offset rims they will sit even with the fenders they won't be sunk into the fender well

 

Ahh ok I see so if I want a slight poke will I have to get - or + off set?

 

You'll want a negative offset some were in the 10 to 15 negative offset

 

Thanx a lot!!

 

Between -20mm and 0mm seems to be the combo to poke them out. +20-40mm will tuck into the fenders.

 

So get 15x8 20 offset for rear? And maybe run 15x8 0 offset for the front?

 

Bump.

 

If you want them to be flush with the body a zero offset would be my choice it's close and looks flush and if your lowered a little front camber keeps them off the fenders . So rubbing and cutting tires is reduced