So as of now i am running 15x8 black Cragars all around. I got a really good deal on some 15x10s. Will they fit and can i stretch my tires to fit?

 

what's the offset on the 15x10s? how low is your truck? what size tires?

 

Ok so i am 3in on torsion bars i have 4x4 fenders and front bumbers. 3in blocks in rear but going lower this summer. I dont know what the offset is but its a pretty large deep dish.

 

you'll be fine then

 

Do you think my tires from my 15x8s would stretch to the 15x10s?

 

What size are they?

 

I've got 215/35/18 on 18x 9.5 on the front and 18x10.5 on the rear

 

just saw the pics in your build thread. if those are the tires you still have right now, they'll stretch on easily.

 

yea you can stretch them no problem.

 

sweet

 

hey, i had a question...

been searching for a while, trying to find the TM guy who's running the new IS-style wheels on his mini. he also got a lifted 4runner w super wide swamper tires. (seen him?) anyways, i wanted to know how he got those wheels to fit, seeing as how the hubs are smaller on those rims than what can fit on the truck

 

You can bore the center out. If a small amount a dremel + test fits will help out

 

215's on a 10.5"? holy **** that's dangerous.

 

That's what I'm bangin !!

 

That's what I had to do with my oz's

 

damn,

...and double damn.

i dont really wanna grind them out.

 

its not that bad bruh, few minutes of work on each wheel and they will fit. or you can just run a small 3mm spacer, although id rather bore the rim to fit.

 

spacer with a hub centric ring somewhere.

 

If u have a steady hand u should be fine but I would recommend using an air grinder with a diamond bit like u would use to port a head or intake runner, Dremel tool could take a little time