ok so i ordered these ball joints for my belltech spindles so i could make lower arms...... http://www.speedwaymotors.com/p/3523,27_Screw-In-Lower-Ball-Joints.html?itemNo=k727 well the castle nut wont thread onto the shaft when i insert the ball joint into the spindle... and if it did it wouldnt tightn down far enough for the cotter pin to go in.....i was informed that these were the correct ball joints...is there somethin i am missin?
question answered....for those interested its a moog K778 for a chrysler...just have to use a spacer between the spindle and the castle nut to space the castle nut even with the cotter pin hole or just drill a new hole for the cotter pin