Chevy v8 swap into a '83

Discussion in '1976-1983 Build-Up/Project Threads' started by Jake pappada, Dec 5, 2016.

  1. Jake pappada

    Jake pappada Newbie

    Joined:
    Dec 5, 2016
    Messages:
    1
    Likes Received:
    0
    Hey everyone new to this forum. I have a fully caged (was told an) '83 I got on a trade. Has solid front axle so sounds right. And the truck was already swapped with a small block chevy so some of the components are there but I need to know what else I need. As of now on the truck the motor mounts exhaust and conversion bell housing is on the stock 5 speed. I need to know if I can get away with just getting a conversion clutch disk with the right number of splines and use stock '76 chevy fly wheel and pressure plate.
     

Share This Page