So I went to check out some pacer wheels, lug measurement was 4.5" (i skipped a lug) however when I went to put the rim on the hub, the bolts were off not even a quarter of an inch. I thought they'd fit since when I measured them they came out the same. The Lugs just weren't lining up.



This is one of the rims.

 

i have a speedwaymotors catalog and it says to measure from the center of one hole, to the outside of the second hole.

 

Man that sucks but if those are 14s I have a set sitting in my garage that got painted black but with a little paint thinner they should get back to there original chrome status. Let me now cause Ill let them go for cheap.

 

Going by where you measured, They're probably 5 x 4 3/4 GM Pattern

 

you measure from center hole to center of the hole that will give u your bolt pattern..