I cannot find a harmonic balancer for my 1990 Toyota pickup 22r engine? The set up of the pulleys is reverse of what is available in stores...
I have a 1986 Toyota pickup 2wd, at the moment it’s got the old 22r that I was planning on putting a big cam in and upgrading a bit, but I’ve also...
[ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH] Hi all, as much as I am torn to do so, I am selling my 1981...
So, my truck being the first carbureted and manual vehicle I've owned, I've a lot to learn about it! Starting off, whenever my truck is...
Just bought my first car a few months back. It's a 1986 Toyota pickup, 2wd, Base model. I joined the forums because I'd like to post a build...
Just pulled the 20R from my '77, and I'm about to swap in an early 22R. I had a question in regards to how to properly route the coolant lines....
Long story short. I had a friend try to help me out and check the timing on the 20R. Driving home I could tell something was way off. Felt much...
Will a Gen 3 with square intake holes and round exhaust holes bolt into my 1986 pickup? Id like to drop this Gen3 block in and connect the intake,...
Hi all, I have recently picked up a 22re from a 95ish pickup and I am going to swap it into my 1977 rn25 in place of the old run down 12r. Is...
Hey guys I have some parts I'm tryna offload. I have a 1975 20r short block complete with pistons and crank. I also have 22r early model short...
Hey, I'm planning on doing a Automatic to Manual swap, and there is this guy that has a G52B manual transmission that came out of a 87 pickup. He...
I am currently building a 77 toyota hilux with the wolverine conversion. I currently have a hybrid 22r/20r head waiting to be put in. I am in...
1981 Toyota Pickup 22r motor for sale. Trying to get enough for it to swap it with another motor but I'm open to offers. New water pump, new fuel...
Just rebuilt an 87 22r engine. .20 over pistons, .10 over bearings, new timing chain set, timing cover, water pump, oil pump, brand new assembled...
Hey guys I have searched all over the place and I'm to the point where I have to post this. Crankshaft has a Groove in it from the rear main seal...
Okay, I have a 86' 22r Xcab Long bed 1/2 Ton with a F302 Rear end in it. According to forum browsing that means I should have a 7.5" 2 pinion,...
Separate names with a comma.