Well after a little break back on it starting a little small as in getting down to cleaning up everything and painting putting the final touches...
Decided to work on the rear lift bars tonight finally burnt up my drill bit that I use for everything so this is as far as I got [ATTACH]still got...
Got the trans member cut out cleaned it up flipped and new mount for trans [ATTACH][ATTACH] Now the exhaust will fit on the passenger side very...
So decided I needed to check how motor sat in frame since i cut all the factory mounts out and rebuilt them [ATTACH][ATTACH] [ATTACH][ATTACH]...
So finally got enough parts in to start some work on this thing [ATTACH] [ATTACH]so this is where I started [ATTACH][ATTACH] [ATTACH]don't think...
Well parts are starting to roll in so decided to get back on it decided to start cleaning the frame up all the old brackets and junk that was on...
Little stuff right now until everything shows up managed to get the motor on the stand tonight and kinda just set everything on it for now...
Thanks and hell I picked mine up for 650 with some assembly required but everything is brand new besides most the obvious I mean injector pump was...
No bed for awhile with the frame work but I do have a short bed to go on it once I get fenders
Ya it took me awhile to track down the 1 ton parts and along the way managed to get two sets but I wanted everything to stay Toyota I had looked...
Build has kinda slowed down trying to get the rest of my parts I need for the diesel swap having to order almost everything overseas and it's been...
Thanks man still a lot to get done it's slowly coming together
[ATTACH] Finally ordered the bellhousing the 22re trans would not mate to the 2l block with the flywheel also having to order the 2wd oil pan and...
I'm hoping so defiantly the end goal don't think there's a Yota diesel Dually build out there yet could be wrong but if not I'm trying to be the...
So things have changed a little the diesel I had for it was originally a Mazda diesel and since I started the hole Dually build I wanted to stay...
[ATTACH] Then started on my plates for frame wasn't sure how I wanted them to look so started with a peace of foam board and went from there...
And done on to the next set [ATTACH] All done by hand
Starting at the rear and making all my support brackets a lot of work to do [ATTACH] Still not done gonna drill some holes to make look a little...
Oh and forgot having to change up bag setup on truck [ATTACH]So gonna run a cantilever setup be a first for me we shall she how it does on it
It depends on metal thickness
Separate names with a comma.