I made a full 2 1/4 system to go behind a Thorley TriY header. I used a straight through glass pack muffler and it's a little too loud for me,...
I'm not sure on the wiring, I'd say find a factory wiring diagram from the year/model Supra you used and decipher what the wires from the trans...
I like this thread... I've always like the way people customize flat beds...when looking for a truck I was OK with buying one with a rusted out...
I put the hammer down today and got it finished. Made the plates out of 3/16". Welded the left side in first. Then hung the box off the two...
I took a break for lunch, and saw this awesome Toyota at the grocery store. Dually flat bed with a hoist! awesome [IMG] Back on the job,...
I bought my 94 shorty in July last year, I looked it over for the usual rust rot that I am aware of on these trucks, didn't see anything bad, just...
I have a very similar noise as well...It didn't do it when I got it in July, but recently I've noticed it but only if I start driving when the...
and if you do end up with a lower to the ground mounted filter, I remember some type of in line foam thing that was to prevent hydro lock if you...
Looking good, nice project you have there.
There are adapter kits/plates to put a 5 speed behind the 1UZ, not sure if your W50 will work with them, it's been many years since I was...
Maybe a custom bed? I've always wanted to make something custom on the back of one of these trucks...either a utility/flatbed customized to haul...
I have a truck I was parting out and making into a trailer, it probably has the line you need. But depending on the length shipping might be more...
I just read this entire thread it's very impressive and informational. I learned a few things reading it. Keep up the good work
Yes I have the door mounted mirrors....so I can just pull the upper portion off first? Do I have to squeeze the sides in or anything or just pull...
I'm trying to figure out how to remove the plastic cover on the side mirror base. My drivers mirror is loose and I need to tighten the bolts. I'll...
I have one still on a motor. I'd have to strip it and remove it. What are they worth? I had been trying to sell the running motor complete but for...
whew it's a long story. Yes I had a fuel pressure gauge between the filter and the rail while driving and it drops when the problem...
Do it! You just need a welder and a way to cut pipe. A local muffler shop I went to sells prebent mandrel pipe in different sizes, with different...
The rear wheel drive celicas are awesome and handle great if it's a GTS with IRS. I swapped a complete Celica Supra rear subframe so I have the...
now that's funny...forward gears gone but you still wanted more burnouts... Awesome swap I'm leaning more towards a 1JZ swap over the 1UZ....
Separate names with a comma.