I made a full 2 1/4 system to go behind a Thorley TriY header. I used a straight through glass pack muffler and it's a little too loud for me,...
I'm not sure on the wiring, I'd say find a factory wiring diagram from the year/model Supra you used and decipher what the wires from the trans...
I like this thread... I've always like the way people customize flat beds...when looking for a truck I was OK with buying one with a rusted out...
I put the hammer down today and got it finished. Made the plates out of 3/16". Welded the left side in first. Then hung the box off the two...
I took a break for lunch, and saw this awesome Toyota at the grocery store. Dually flat bed with a hoist! awesome [IMG] Back on the job,...
I bought my 94 shorty in July last year, I looked it over for the usual rust rot that I am aware of on these trucks, didn't see anything bad, just...
I have a very similar noise as well...It didn't do it when I got it in July, but recently I've noticed it but only if I start driving when the...
and if you do end up with a lower to the ground mounted filter, I remember some type of in line foam thing that was to prevent hydro lock if you...
Looking good, nice project you have there.
There are adapter kits/plates to put a 5 speed behind the 1UZ, not sure if your W50 will work with them, it's been many years since I was...
Maybe a custom bed? I've always wanted to make something custom on the back of one of these trucks...either a utility/flatbed customized to haul...
I have a truck I was parting out and making into a trailer, it probably has the line you need. But depending on the length shipping might be more...
I just read this entire thread it's very impressive and informational. I learned a few things reading it. Keep up the good work
Yes I have the door mounted mirrors....so I can just pull the upper portion off first? Do I have to squeeze the sides in or anything or just pull...
Separate names with a comma.