I recently acquired an s2000 for a motor/transmission swap. During the tear down, I noticed the springs that were in it (Eibach) were the same...
The 2wd Nissan hubs use the same bearings as the 2wd Toyota's. You'll run in to a couple of obstacles though. The first is the spacing. The...
That is very true. LS is light. Older SBCs are pigs. haha
An LS isn't all that heavy in terms of engine weight - especially considering how heavy the iron block 8/18RC's are. Those old Toyota 4 cylinder...
49 months apart. Nice setup though.
I've got 4.10s now. If I end up doing a swap, I don't want to be geared too tall so probably. 3.90 or 3.73.
In an effort to consolidate any info I find on the conversions, here are a couple of links for some of the options I've found. Again, the are...
I know I've read it somewhere but can't remember when Toyota decided to ditch the G-code (8") for the F-code (7.5"). I think it was late 70's....
From what I understand, the brackets allow the V6 calipers and rotors to be used on the rear of just about any 7.5" or 8" toyota rear end -...
I'll do that. Thanks for the lead.
I've been working on my 1971 since winter grabbed Utah by the nuts. I sourced an MKIII Supra LSD which is in the process of a rebuild (Weir...
I know for a fact (I took it apart to mount an MKIII Supra LSD in it) that my 71 is a G-code and has 30 splines.
I've been contemplating the same swap into my 71. Looking at it, there's not much room as Cade01 mentioned. I know there are alternator brackets...
Im trying to figure out a rear disc setup but until then, I need a drum backing plate from a 1968-72 Hilux. I'm not sure if a 72-77 one would work...
Separate names with a comma.